Test Commands

• ble gatt - GATT-level BLE Tests
• ble test - Low-level BLE Tests
• bledis - Test BLE Discovery
• canCfg - Configure CAN interface
• canClear - Configure CAN interface
• canMatch - Match received CAN message
• canSend - Send CAN message
• define - Define user key
• erase - Erase DUT Flash
• eval - Evaluate Expression
• freq - Frequency Monitor Control
• ftdiCfg - Configure external FTDI
• ground - Ground Selection
• identify - Identify DUT
• image - Set background image
• label - Set Label Substitutions
• measure - Probe Measurement
  • measure <channel> - Take a measurement of a signal.
  • measure start and measure stop - Take continuous measurements over time.
• mux - Multiplex Control
• nfc - NFC Interaction
  • nfc ntag-detect - Detect and identify NFC tags.
  • nfc write - Write NFC tag data.
• operator - Operator Test
• pin - Digital pin control
• power - Power Control
• program - Program DUT
• resume - Control resume behavior
• scan - Scan Barcode
• serial - Request or set serial number
• short - Connect Multiplex channels
• sleepms - Delay
• uart - Send and Extract UART response
• uartAwait - Await UART response
• uartCfg - Configure UART
• uartExpect - Set expectation for uartAwait
• uartReadTimeout - Test if UART is not transmitting
• usb - USB Interaction
  • usb detect - USB Device Detection
  • usb power - USB Port Power Control
  • usb reset - USB Reset
  • usb storage - USB Storage
    • usb storage mount - Mount USB Mass Storage Device
    • usb storage unmount - Unmount USB Mass Storage Device
    • usb storage write - Write to a USB Mass Storage Device
• wait - Delay
• webhook - Invoke webhook